Function of pure sine wave inverter
Inverter output function:
Open the inverter switch in the front of the panel, the inverter is about to change the DC power of the battery into pure sine wave alternating current, output by the ACOUTPUT of the rear panel.
Automatic voltage stabilizing function:
When the battery voltage is fluctuated between the undervoltage and the overvoltage, and the load is changed in the rated power, the device can
automatically output voltage.
When the battery voltage is fluctuated between the undervoltage and the overvoltage, and the load is changed in the rated power, the device can
automatically output voltage.
Overvoltage protection function:
When the battery voltage is greater than the overvoltage, the device will automatically cut off the inverter output, the front LCD panel display “overpressure”, the alarm sound and the buzzer sends out ten seconds. When the voltage is down to “overvoltage recovery point”, the inversion recovery work.
Undervoltage protection function:
When the battery voltage is lower than the “undervoltage point”, in order to avoid excessive discharge to damage the battery, the device will automatically cut off the output. At this time, the front panel LCD display “undervoltage”, and the buzzer alarm sound ten seconds. When the voltage is up to the “undervoltage recovery point”, the inverter recover to work; if there is a switching device, automatically switch to the city output when undervoltage.
Overload protection function:
If the AC output power exceeds the rated power, the device will automatically cut off the inverter output, the front panel LCD display “overload”, at the same time, the buzzer sends out ten seconds alarm sound. Off the front panel of the “inverter switch”, “overload” display disappeared. If you need to reboot, you must check to confirm the load in the allowable range, and then open the “inverter switch”, to restore the output of the inverter.
Short circuit protection function:
If the short circuit of the AC output circuit, the device will automatically cut off the inverter output, the front panel LCD display “overload”, at the same time, the buzzer alarm ten seconds. Off the “inverter switch” of the front panel, “overload” display disappeared. If you need to reboot, you must check to confirm the output circuit is normal, and then open the “inverter”, to restore the output of the inverter.
Overheating protection function:
If the temperature of the control part of the internal chassis is too high, the device will automatically cut off the inverter output, the front panel LCD display “overheating”, at the same time, the buzzer sends out ten seconds alarm sound. After the temperature is restored to the normal value, the output of the inverter is recovered.
Battery reverse protection function:
If the positive and negative polarity of the battery reversed, the chassis of the fuse will automatically fuse to avoid damage to the battery and equipment. But it is still prohibited to reverse the battery!
The optional city power switching function:
If choose the city power switching function, when the battery undervoltage or inverter failure, the equipment will automatically switch the load to the city power supply, so as to guarantee the stability of the power supply to the system. After the inverter can work normally, it will automatically switch to the inverter power supply.
评论
发表评论